Amendments To The Cabinet Of Ministers Of 12 June 2001, The Regulation No 241 "katliekārt Technical Monitoring Procedures"
Original Language Title: Grozījumi Ministru kabineta 2001.gada 12.jūnija noteikumos Nr.241 "Katliekārtu tehniskās uzraudzības kārtība"
Read the untranslated law here: https://www.vestnesis.lv/ta/id/98528
Cabinet of Ministers Regulations No. 1042 Riga 2004 December 21 (Mon. No 74 13) amendments to the Cabinet of Ministers of 12 June 2001, the Regulation No 241 "Katliekārt technical procedures for supervision" Issued in accordance with the law "on technical supervision of dangerous equipment," the second part of article 3 to make a Cabinet of 12 June 2001, the Regulation No 241 "Katliekārt technical monitoring procedures" (Latvian journal, 2001, 93 no) the following amendments: 1. Replace the text, the words "the competent authority" authorized inspection (the fold) with the words "inspection body" (fold). 2. Express 2.2. subparagraph by the following: "2.2. katliekārt where the manufacturer's stated capacity of 500 kilowatts or less." 3. Make paragraph 3 by the following: "3. The Ministry of economy in cooperation with the relevant technical standards Committee recommends limited liability company" Latvian standards "in connection with these terms, reliance and designing standard applicable list." 4. Delete paragraph 4, the words "State non-profit". 5. To complement the chapter 1 with 4.1 and 4.2 point as follows: "Katliekārt of technical inspection 4.1 is entitled to take an accredited institution, for which the economic Ministry has published a notice in the newspaper" Gazette "(hereinafter referred to as the inspection authority) if it: 1.4.1 is accredited Latvian National Accreditation Bureau according to the standard EN 45004" EN main criteria in different types of bodies performing inspection "and the requirements of these regulations; 4.1 2. insure your have civil liability for an amount to cover the possible losses incurred by mistake, which, in cooperation with the institutions of the selected insurer calculated the areas of activity of the institutions of the risk assessment. 4.2 Latvian National Accreditation Bureau will evaluate and monitor the adequacy of inspection bodies referred to in point 4.1 requirements. " 6. To express the point 7 by the following: "7. every katliekārt needs a passport in the national language. Possessor who initiated the use of the equipment in Latvia, fill out a passport in accordance with the provisions of the model Passport set out in the annex. " 7. Make the introductory paragraph 8 by the following: ' 8. Katliekārt Passport accompanied by a declaration of conformity according to the Cabinet of Ministers of 2 May 2000, the Regulation No 165 "provisions of the pressure equipment directive and the requirements of complex" or statement of compliance of the Member States of the European Union, good technology practices: Cabinet 2 May 2000 No. 165 of the provisions of the "pressure equipment directive and the rules package" 20. in the case referred to in paragraph. The Passport also adds the Assembly and operating instructions in the language of the country. The instruction specifies the following information: ". 8. Add to paragraph 8.5. beyond words "directions" with the words "or if the possessor intends to extend the life of katliekārt (resources)". 9. Express 11.1. subparagraph by the following: "11.1. provide katliekārt service a sufficient number of staff that is trained and instructed in accordance with the laws and regulations on the protection of health, the use of work equipment, as well as to provide training of personnel labour protection matters, taking into account the design and use of katliekārt conditions;". 10. Supplement with 11.1 points as follows: "the main technical Katliekārt 11.1 the descriptors of the possessor of the reduction of katliekārt with inspection bodies and shall carry out the appropriate entry in the Passport katliekārt. If katliekārt is significantly changed constructs or basic technical characteristics, the possessor shall ensure compliance with the Cabinet of katliekārt of 2 May 2000 the Regulation No 165 "provisions in the pressure equipment directive and their complexes." " 11. Make the following point 1.4. "13.9. stop katliekārt if its use endangers human life, health, property and the environment, as well as the time limit provided has not been katliekārt according to the technical examination of this provision and paragraph 63.64." 12. Add to 55 after the word "Katliekārt" with the words "elements and". 13. Express section 67.1. as follows: 67.1. test pressure "(PT) must not be less than 1.25 PS and PT = Rm/20/Rm/t, where PS: maximum pressure in bars; RM/20-katliekārt-strength limits the minimum value of 20 ° C; Rm/t-katliekārt-strength limit calculation temperature; ". 14. the annex shall be deleted, the words "the manufacturer's trade mark (logo)". 15. Replace Annex number and the words "1. Manufacturer and address" with a number and the words "1. Manufacturer or supplier and address". 16. Replace Annex number and the words "2. Supplier and address" with a number and the words "the possessor and the 2 address".
17. Replace the words "in annex Katliekārt manufacturer (signature and transcript)" with the words "Katliekārt the possessor (signature and transcript)" Prime Minister a. Halloween economic Minister A.r. Kariņš
Search Translated Laws of Latvia