Cabinet of Ministers Regulations No. 775 in Riga in 2005 (October 18. No 60 6. §) rules on customs security Issued in accordance with the customs law article 4, third paragraph i. General questions 1. rules determine the types of customs security, its use and exchange procedures. 2. the coverage is the product identification tool that is used to prevent uncontrolled access to the goods, the transport means, commercial premises and other places where the goods subject to customs control. 3. the customs security shall: 3.1 the Customs seal;
3.2. the Customs label;
3.3 the photo and the description of the goods;
3.4. other types of collateral in accordance with the provisions of paragraphs 8 and 16. II. the use of the customs security 4. customs security shall apply: 4.1 of the Customs Act article 11, first paragraph in those cases;
4.2. If the requested goods, commercial vehicles, space and place in which the goods subject to customs control, the owner, possessor or their authorised persons or goods carrier. In this case, the customs officer is not entitled to withdraw from the security. 5. customs security shall not be used: 5.1 heavyweight, oversized and uniform of loose cargoes;
UR5.2.dz array of animals in accordance with the Council on 23 July 1987, Regulation (EEC) No 2658/87 on the tariff and statistical nomenclature and on the common customs tariff;
5.3. If it is physically impossible to impose a particular shipment customs security. 6. At the same time allowed to use several types of customs security. One Customs seal may be replaced with another type of customs security. 7. customs security used their identification number in ascending order. 8. The Person to whom the regional customs authority issued the local clearance permission, which gives the right to impose a Customs seal without the presence of customs officials, the seals can be purchased in the State revenue service's main customs administration or with the permission of the Customs authorities to use other types of collateral, consistent with the Commission's July 2, 1993, Regulation (EEC) No 2454/93 laying down provisions for the implementation of Council Regulation (EEC) No 2913/92 establishing the Community customs code 46. Annex, conditions. 9. The State revenue service's main customs administration implements the provisions of customs securities. 8 persons referred to in paragraph 1, in accordance with the rates laid down in the legislation. 10. Customs seals (annex 1) is used, if it is possible to impose a seal or a special place. 11. The Ribbon Seal used by the Customs authorities. Trosīšveid seal uses both the Customs authorities and the people who receive the local clearance permission. 12. Customs seals shall be deemed to be imposed, if the Customs seals or the Ribbon reverser attached to the customs, taxation, security has been strengthened through the Ribbon or trosīšveid seals locking mechanism. 13. following the imposition of a Customs seal, the customs officer or the person who received the local clearance permits, goods (cargo) the accompanying documents and the customs declaration shall indicate the number of seals and identification numbers and confirm it with the signature and stamp of the customs. 14. the Customs label (annex 2) is used, if it is not possible to use the Customs seals. After the imposition of the Customs label customs officer or the person who received the local clearance permits, goods (cargo) the accompanying documents and the customs declaration specifies the number of labels and identification numbers and confirm it with the signature and stamp of the customs. 15. The photos and item descriptions are used to move the art and vintage items, moving items between customs authorities, or that rule 4.2. in the case referred to in subparagraph. Photos and description of the goods, regardless of the competent authorities, the documents issued by the experts are considered Customs seal, after approval by the customs officer with the signature and stamp of the customs. After approval of the description of goods are not allowed to make additional entries. Photos and description of the goods shall be added to the accompanying goods (cargo). 16. in the Republic of Latvia in accordance with the concluded inter-governmental agreements on customs security are recognized customs security of other countries, if they are not damaged and comply with paragraph 2 of this rule. 17. If the other country imposed customs security is recognized as a customs security of the Republic of Latvia, the customs officials in customs documents the Customs seal numbers and identification numbers and confirm it with the signature and stamp of the customs. III. Customs security exchange 18. customs security may change the customs official performing customs inspection of goods, not less than two outside parties (other than customs officials) the presence in the following cases: 18.1. If the previous customs seal is damaged, poorly legible or lost;
18.2. the customs control of goods;
18.3. If the goods are partly implying or addition. In this case the Customs seal may also change the person who has received the local clearance permission. 19. changing the security for Customs officers of customs inspection of the Customs Act in duplicate. The Act specifies the type of the previous customs and also, where possible, identification numbers, replacement of the customs security reasons and new customs security and identification numbers, as well as the description of the previous customs security situation and product inspection results. 20. the customs inspection act with the signature and stamp of the approved private customs officer making the inspection, as well as the signature of at least two of the invited person. One customs inspection a copy of the Act adds a document accompanying goods (cargo), and another deposit of the Customs office where the customs officer has changed. 21. Concerning Customs security replacement correcting the documents accompanying the goods (cargo). Customs officers of customs fixes confirms with a Customs seal and signature. Prime Minister a. Halloween Finance Minister o. Spurdziņš annex 1: Cabinet of Ministers of 18 October 2005, the Regulation No 775 Customs seals Ribbon Seal Tyden 1 Seal (Figure 1) consists of: UR1.1.met ALA Ribbon, which length is cm, width: 0.95 21.43 cm on the tape is "Latvian customs" and the identification number consisting of two letters and six digits; 1.2. the locking mechanism. 2. Ribbon Seal has an extending the width of the Ribbon that is 4-5 mm, perforated 8-12 mm in length, and the interval between perforated 13 mm. Fig. 1 3. Trosīšveid sealed EZ Loc (Figure 2) shall consist of: the locking mechanism 3.1-seal head, in which some letters EN and the identification number consisting of six digits; 3.2. reverser that length 400 mm, diameter 1.6 mm. Figure 2 Finance Minister o. Spurdziņš annex 2 Cabinet of 18 October 2005, the Regulation No 775 customs sticker 1. Customs label is the high degree of stickiness self-adhesive sticker, which cannot be removed without damaging it (tearing, not deformation).
2. the Customs label length is 180-240 mm, width 20-40 mm. 3. a customs sticker identifying marks are the words "Latvian customs" and "CUSTOM", under the identification number consisting of two letters and five digits.
4. Exhibit — tape 38 mm. width: 4.1, not limited in length;
4.2. color: Green;
4.3. material: strong enough both for use and storage;
4.4. use consumables customs label. Minister of finance Spurdziņš o.