Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006
Amendment 1
 
I, JAMES ERIC LLOYD, Minister for Local Government, Territories and Roads, determine this vehicle standard under subsection 7 (1) of the Motor Vehicle Standards Act 1989.
 
 
 
 
Dated               5th October 2007
 
 
 
 
 
 
 
 
 
 
 
 
[SIGNED]
 
 
 
James Eric Lloyd
 
Minister for Local Government, Territories and Roads
 
CONTENTS
 
 
1.           legislative provisions. 3
2.           AMENDMENT of vehicle standard.. 3
SCHEDULE 1. 4
 
1.                     legislative provisions
1.1.                  Name of Legislative Instrument
1.1.1.               This Instrument is the Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006 Amendment 1.
1.2.                  Commencement
1.2.1.               This Instrument commences on the day after it is registered.
2.                                          AMENDMENT of vehicle standard
2.1                   The changes specified in Schedule 1 amend Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006
SCHEDULE 1
 
[1]                   Replace Clause “6.4.1 for any point in the width of the vehicle which is within one metre fore and aft of any ‘Axle’, 100 mm;” with;
 
 “6.4.1             [This clause has been deleted]”
 
[2]                   Add Clause
“6.6                 The ‘Running Clearance’ of a vehicle, other than an L-Group vehicle must be not less than 100 mm.”