Cabinet of Ministers Regulations No. 728 in 2011 (27 September. Nr. 55) amendments to the Cabinet of Ministers of 30 April 2001, regulations No 181 "construction products conformity assessment procedures for the regulated sphere" Issued in accordance with the law "on conformity assessment" of article 7 and article 25 of the law on construction of the second part 1. make Cabinet 30 April 2001 No. 181 "in the terms of construction products conformity assessment procedures for the regulated sphere" (Latvian journal, 2001, 68 no; 2004, 68 no; 2009, 2010 29 no; 45. No.) the following amendments: 1. Express 1.1 point as follows: "1.1 subject to the provisions for incorporation of fixed structures or parts of structures (construction) for construction products, the conformity of which to be determined in accordance with the provisions referred to in paragraph 4 of the technical requirements of the rules.";
1.2. Express 4 and 4.1 paragraph by the following: "4. the technical rules governing construction products are as follows: 4.1 national standards, which list shall be drawn up by the Ministry of the economy, from the list of standards in coordination with the responsible Ministry. The list is published in the society with limited liability "the standardization, accreditation and Metrology Centre ' standardisation Bureau homepage on the internet (www.lvs.lv) and the Latvian newspaper" journal "not less than annually;
4.2. The Latvian national standard in compliance with the construction products adapted to the status determination is applicable to the European Committee for Standardization CEN and the European Committee for Electrotechnical Standardization CENELEC standards (including this section of the standards that apply to European Union legislation in the field of construction products (Informative Annex ZA)), to which reference is published in the official journal of the European Union and national adaptation of the list with a reference to the official journal of the European Union published standards drawn up by the Ministry of the economy. The list is published in the society with limited liability "the standardization, accreditation and Metrology Centre ' standardisation Bureau homepage on the internet (URwww.lvs.lv);
4.3. the European technical approval guidelines and that the application of the guidelines as the starting date in the Ministry of the economy shall be published in the newspaper "Gazette";
4.4. Published in the official journal of the European Union, the European Commission announced the determination of conformity of construction standards that are applicable to the Member States of the European Union forwarded to the Commission of the European Union as national standards in these countries and a list of the Ministry of economy has published the newspaper "journal".
4.1 4.2. These provisions of the standards referred to in the Ministry of the economy include the list in the official journal of the European Union, reference standards specified on the start date and the introduction of standard end date of the transitional period, but these rules 4.1 and 4.4. list of standards referred to as standards start date and the end of the period of implementation of a standard date. ";
1.3. to supplement the provisions under point 4.2 of the following wording: "this provision 4.4 4.2 referred to technical provisions may apply if the products concerned does not have the technical provisions referred to in this rule 4.1, 4.2 and 4.3 above.";
1.4. make points 6 and 7 by the following: "6. the materials permitted to offer the market of Latvia, if those are the rules of compliance referred to in paragraph 17 of the supporting documents and markings in accordance with the provisions of Chapter VII. On the offering of the Latvian construction products on the market without appropriate supporting documents for compliance with the perpetrators held to account under the procedures laid down by law.
7. compliance with the provisions Of this and of the attestation of conformity of construction products before their release for the Latvian market by the manufacturer or its authorized representative, but for construction products imported, the importer. The appropriate offering of construction market of Latvia is responsible distributor of construction products. ";
1.5. to replace the words in paragraph 7.1 2. "manufacturer (supplier)" with the words "manufacturer or their authorized representatives";
1.6. delete paragraph 17.2. numbers and the words "in paragraph 22 (System 2 and 2 +);"
1.7. to supplement the rules with 22.5 points by the following: "If 22.5 the manufacturer or its authorised representative not applied or has only partly applied the existing technical regulations, which provides that the attestation of conformity shall be carried out in accordance with this rule 22.1 points (System 3) or 22.2 points (System 4) conformity assessment system set not lower for this rule 22.1 points (System 3).";
1.8. make 23, 24 and 25 of the following paragraph: "the attestation of conformity of construction products 23 if they are made individually to order or industrial process of production by special order and incorporated into a single building, it is identified with the Declaration of conformity in accordance with the provisions of article 25 and the requirements referred to in paragraph 22.1 (3), if the technical regulations applicable to human life, health and safety or environmental risks not otherwise specified.
24. The dossier on the basis of which issued the attestation of conformity of construction products, and Declaration of conformity the manufacturer store to make it available to the market surveillance authorities and notified bodies for at least 10 years after the cessation of production of the products in question. If the manufacturer of construction products in the European Union is not in a registered person for the maintenance of the documentation is the responsibility of the European Union established in the procedure laid down in the manufacturer's authorized representative or the importer of the products.
25. for each batch of the materials produced by the manufacturer or his authorised representative shall draw up a declaration of conformity the manufacturer (also where the notified body has issued certificate of compliance). A copy of this Declaration by the manufacturer, its authorized representative, importer and distributor shall be added to each market of Latvia proposed delivery lot. The Declaration of conformity be drawn up in accordance with the technical regulations specified in the form of the Declaration of conformity. If the technical provisions of the Declaration of conformity is not specified the form and content of the Declaration of conformity be drawn up in accordance with the standard LVS EN ISO/IEC 17050-1:2005 "conformity assessment-supplier's Declaration of conformity — part 1: General requirements". In particular, the Declaration of conformity: 25.1. a manufacturer or its registered European Union authorized representative's name and address;
25.2. the description of the products (for example, type, class, class, class);
25.3. technical regulations and other normative acts, which corresponds to construction products;
25.4. specific conditions for the use of construction products;
25.5. the notified body, if the name and address of the notified body involved in the construction products conformity assessment;
6. name, surname and position of the person empowered to sign the Declaration of the manufacturer or his authorised representative. ';
1.9. Express 34 34.1 points and the following: 34. "placing on the market of construction products conformity assessment carried out in accordance with this rule 4.2, 4.3 or 4.4. technical provisions referred to, it will be labelled with the CE mark. The manufacturer or its authorised representative shall be marked with the CE marking of construction products in accordance with the rules laid down in annex 2, which is complemented by this provision of the information referred to in paragraph 36.
If certain technical rules 34.1 conformity assessment procedure notified body involvement behind the CE mark indicates the identification number of the notified body. ";
1.10. to make 35 as follows: ' 35. the CE marking of construction products, construction products placed on labels, packaging materials or the accompanying commercial documents (in the sense of these provisions the attestation of conformity of construction products shall not be deemed as the accompanying commercial documents) clearly visible, legible and indelible manner. ";
1.11. to make 42 as follows: "42. Market surveillance of construction products offered in the safety of goods and services in the law and in accordance with the procedure laid down in these provisions make the market surveillance authority – consumer protection Center. Market surveillance body shall have the following rights: 42.1. visit of construction for the production, storage and sales outlets, as well as building the site with them;
26.2. to require from the construction products manufacturer, his authorised representative or the importer referred to in paragraph 24 of the rules technical documentation;
26.3. take samples of products and organize their expertise to assess the conformity of the construction requirements of these rules;
26.3. to require from the construction products manufacturer, his authorised representative, the importer or the Distributor's compliance with the supporting documentation. "
1.12. to replace the words "in paragraph 45, the manufacturer or importer to market surveillance authorities within a specified time limit, at its own expense, carry out a repeated evaluation of the eligibility of the construction according to the requirements of these regulations" with the words "considers that the construction products have not undergone conformity assessment";
1.13. Express 46.1 points as follows:

"Building out the construction process 46.1 in the monitoring of the construction products used. Building have the following rights and duties: 1. to enter the construction site 46.1 and to check the conformity of the construction products in paragraph 2 of these regulations and technical requirements laid down in the rules, get the accompanying documents and the conformity of construction products supporting documentation and, if necessary, organize the inspection of construction products;
46.1 2. jointly with the consumer protection officials of the centre point of the marketing of the construction products market construction products that could be offered to verify compliance with this provision in paragraph 2 and technical regulations;
46.1 3. stop the works if it is established that the construction used in the regulated sphere of construction products, which have undergone specific technical regulations conformity assessment to be certified with a certificate of compliance and Declaration of conformity in accordance with the provisions of subparagraph 17.1. or with a declaration of conformity in accordance with the provisions of subparagraph 17.2;
46.1 4. jointly with the consumer rights protection centre officials go on the manufacture of construction products, check with the conformity assessment of the products of the associated documentation and organize materials sampling and production control system audit, if market surveillance established in the on-site materials produced by the non-compliance;
46.1 5. informing the consumer rights protection centre of the discrepancies identified in written or electronic form, providing information on non-conformity of the products, as well as other available information on suppliers and producers of construction. "
2. the rules shall enter into force on the 1 October 2012.
Prime Minister v. Economic Minister Dombrovskis a. camphor